Skip to content

Home / Technique / Anchoring

Anchoring

Anchoring: scope, setting and staying put.

Anchoring comes down to letting out enough rode, getting the anchor to dig in, and confirming it holds. Sources agree on the principles and disagree on the numbers.

Get trained

This page explains the principles. It is not a substitute for hands-on instruction from a recognized program such as US Sailing, the RYA or ASA, and it does not replace the safety rules that apply where you sail.

Scope: how much rode to let out

Scope is how much anchor rode you let out compared with the depth. ASA says the depth used should include the height of the bow above the water, not just the water depth. Its worked example: 10 ft of water plus 4 ft of freeboard is 14 ft, and at 7:1 that calls for 98 ft of rode.

The ratio itself is where sources part ways:

SourceScope given
ASA7:1 described as typical
Boating Magazine (Joe Friedman)Start at about 8:1. As little as 4:1 possible with heavy chain. Up to 10:1 in poor holding or strong wind
UK Sailmakers (Darren Seltzer, describing his own cruising practice)5:1 normally, 3:1 as a minimum, 7:1 in winds up to about 20 knots, 10:1 in bad conditions

Friedman and Seltzer both call for more scope in strong wind or poor conditions, and ASA gives 7:1 as typical. There is no single agreed number, so treat these as each source's own starting point and learn what suits your boat and local conditions from an instructor.

Chain

Friedman (Boating Magazine) says chain lowers the angle at which the rode pulls on the anchor, absorbs shock and resists chafe. For overnight stays he suggests chain of about half the boat's length. Seltzer (UK Sailmakers) recommends a long elastic snubber to absorb shock loads. Anchor types and rode are covered on anchors and ground tackle.

Setting the anchor

ASA's principle is to approach slowly, heading into the wind, lower the anchor once the boat has stopped, and pay out rode as the boat drifts back.

Friedman and Seltzer both warn against rushing the next stage:

  • Friedman says putting the engine in reverse too early can make the anchor skate across the bottom instead of digging in.
  • Seltzer recommends gentle reverse first to load up the chain, before using higher engine revs, and keeping a hand on the rode to feel for skipping, which is a sign the anchor is dragging.

Checking it holds

Friedman recommends confirming the anchor is holding using landmark transits, GPS, radar or the depth sounder. He also recommends setting a GPS anchor alarm.

Anchoring etiquette

ASA's guidance for a shared anchorage:

  • Give earlier arrivals room.
  • Do not anchor close beside a lone boat.
  • Keep noise down.
  • Show you are anchored: an anchor light at night and a black ball by day.

Check the current light and shape requirements for where you sail with your local authority. The basics of the rules of the road are on rules of the road.

Emergency anchoring

US Sailing's Basic Keelboat lists emergency anchoring among the knowledge requirements for its entry-level certification, alongside rescue methods and distress signals. It is a skill to learn in a course rather than from a web page; see learning to sail.

Gear for anchoringAnchors →Rope and line →Paid links

Keep reading

Disclosure TheGearSports Sailing is reader-supported. When you buy through links on our site, we may earn an affiliate commission at no extra cost to you. As an Amazon Associate we earn from qualifying purchases. Our recommendations are independent.